SELING steel forms are the result of our long experience and years of development and improvement by our professional engineering staff. Due to the unit-composed concept and its versatility, these systems can be tailored to your company’s unique requirements.

The following steel forms are exemplary for our product range:

Produce components from 55 cm to 305 cm in height
Thickness of wall: 20 cm.

This steel form comes with two base forms (one large and one small) which allows you to produce two components at the same time (i.e. 1x H = 255 cm and 1x H = 55 cm).

Wall Height H [cm] Effective Length [cm] TW [cm] TB [cm] 305 100 20 20 280 100 20 20 255 100 20 20 230 100 20 20 205 100 20 20 180 100 20 20 155 100 20 20 130 100 20 20 105 100 20 20 80 100 20 20 55 100 20 20

click wall height for additional info

Produce components from 55 cm to 455 cm in height
Thickness at top always 20 cm

Height: 455 - 430 cm	Thickness: 20 to 30 cm (top to bottom)
Height: 405 - 330 cm	Thickness: 20 to 25 cm (top to bottom)
Height: 305 - 55 cm	Thickness: 20 (consistent)

Wall Height H [cm] Effective Length [cm] TW [cm] TB [cm] 455 100 20 auf 30 30 430 100 20 auf 30 30 405 100 20 auf 25 25 380 100 20 auf 25 25 355 100 20 auf 25 25 330 100 20 auf 25 25 305 100 20 20 280 100 20 20 255 100 20 20 230 100 20 20 205 100 20 20 180 100 20 20 155 130 20 20 130 100 20 20 105 100 20 20

click wall height for additional info

Note: Site specific design must always be provided by a licensed Professional Engineer, who is familiar with the actual site conditions, materials and practices.

• rugged, solid construction with a long service life and very low dimensional tolerances
• one worker per form during the entire production process
• manufacture corner components for various degrees using the standard steel form
• clean and precise edges through welded-on bevelled profiles
• fast and easy handling, due to the bolted joint system
• short conversion times with predefined adjustable grids to set wall height
• unit-composed system offering interchangeable parts to adjust wall thickness
• unlimited surface design possibilities by placing form liners into the mould
• minimum of wear parts